Everest Leo
3D Modeling and Printing
28 March 2023
Day 7: I Have a Porsche!... logo model (Everest Leo)
Today was not an easy day. The designing wasn't very hard in itself but the intricacies and the amount of time that designing this 3D logo consumed are astonishing. To add to that, I have been extremely tired the entire day and so it was hard to focus the entire way through which was annoying (even though we have long 20-minute breaks). I kept on microdozing. This means that it was definitely less efficient than it could've been, but either way, the result of this is that there is not too much to write about.
I recreated the horse the letters and the design on the top left and bottom right of the crest. This plus the extrusions on the other part of the logo to the right is what took up most of today. The reason there are two parts is so I can print them in different colors and hopefully they'll fit together when I print them out, so it'll look cooler.
I also reprinted my rings in a new material we just got called TPU. It is a lot more flexible and feels like rubber so it's quite nice for some fake rings because they imitate silicone. Surprisingly, all the detail was still there, but due to the sticky nature of the material, it took a lot more effort to clean up the supports on the ring than it did when I printed it in PLA, which is much more rigid.
Comments
Post a Comment